Precor P80 Service Manual page 82

If the Status shows Connected and the IP Address is "all zeros", it will be necessary to either have the
4
P80 software assist in acquiring the IP Address (Recommended) or enter the IP address manually.
Touch Configuration from the Connectivity menu.
Touch on the radio button next to Automatic, and then touch SETTINGS.
5
The P80 will attempt to connect to the network, and when successful will acquire the networking
6
information necessary for registration. If the console was already connected, it will skip straight to the
'Network Settings' screen and display the current network information. Once a good IP Address has
been acquired, the P80 can now be registered. Continue with step 12.
Note: Automatic configuration will make up the vast majority of all installations. If
the installation requires a manual configuration, you will be notified as such within
the installation paperwork. If a manual configuration is indicated, precede with
steps 7 - 11 only with assistance from the facilities IT personnel.
Manual Configuration Steps Only:
Touch CONFIGURATION from the Connectivity menu.
7
Touch on radio button next to Manual, and then touch SETTINGS.
8
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Figure 58: Connectivity Automatic Screen
Page 80