Table of Contents
Advertisement
6. Grasp the handle of the hard disk's carrier and unlock the lever located at the
bottom of the carrier handle, see Figure 4-42. The hard disk carrier will
come out approximately 1/2-inch so that its handle is fully accessible in
order to pull the carrier the rest of the way out of the bay.
7. Remove the hard disk drive and place it in an antistatic wrapper.
8. If another hard disk drive is not going to be installed into the vacant slot then
a dummy drive carrier must be. This will ensure proper system cooling.
9. Close the hard disk drive bay door and tighten its thumbscrew.
10. If tower-based system, close the front door of the cabinet.
11. Plug in the power cords and power up the system.
4-46 Disassembly and Reassembly
Figure 4-42. Removing a Hard Disk Drive
Advertisement
Table of Contents
Troubleshooting
