Raid Controller Board - NEC EXPRESS5800/140Hb Service Manual

RAID Controller Board

Use this procedure to install a RAID controller board.
1. Install the RAID controller board into any PCI expansion slot on the system
board. See subsection Installing an Option Board earlier in this chapter.
Note:
#1 or #2 the board will operate in 32 bits only.
2. Cable the RAID controller board as described below (see System Cabling in
Appendix C):
Remove the end of the SCSI interface cable that is plugged into the Ultra-
!
160/m SCSI connector (B) on the system board (A), see Figure 4-26.
Figure 4-26. Locating the Ultra-160/m SCSI connector
Recable SCSI interface cable by passing it to the RAID controller board
!
(B), as shown in Figure 4-27.
Reconnect the end of the SCSI interface cable just removed into the
!
Channel 2 connector on the RAID controller board (A), as shown in
Figure 4-27.
Figure 4-27. Recabling the SCSI Interface Cable to the RAID Card
4-32 Disassembly and Reassembly
If a RAID controller board is installed in PCI slots
A
A
B
B