Attaching The Center Slide Bar To The Server - NEC EXPRESS5800/120Rc-2 Service Manual

Attaching the Center Slide Bar to the Server

Note:
not factory-installed on your server. If the center slide rails
are installed on each side of your server, go to "Installing the
Slide Rail Assemblies into the Rack Cabinet."
Using the two center slide bars removed in the previous procedure attach them
to the server as follows:
1. Align the mounting holes in each slide bar to the threaded holes on the side
of the server (see Figure 2-4).
Note:
one way with the holes in the server.
2. Secure each slide bar to the server with four screws, as shown in
Figure 2-4.
A
B
C
Figure 2-4. Attaching the Inner Component Slide Bar to the Server
2-8 Setting Up the System
Perform this procedure if the center slide rails are
The holes in the two center slide bars line up only
D
A. Center Slide Bar (2)
B. Safety Latch
C. Screws (1 of 4)
D. Threaded Holes in server