Sleep Mode - NEC EXPRESS5800/140Hb Service Manual

Table 1-6. Hot-Swap Fan Module POST Error Codes and System Event Log (SEL)
Item
POST Error Codes
System Event Log (SEL)

Sleep Mode

The SLEEP mode switch on the front of the server is used for saving power.
If the SLEEP mode switch is pressed, then the server enters into the sleep state (the
Drive Bay Power lamp and the Power lamp will blink simultaneously). In the power
saving mode, the memory data and the states of the jobs are kept unchanged. In
addition, the server in the power saving mode can accept accesses to hard disks from
other machines on the network and perform other network jobs.
Sleep mode requires an operating system that supports its function.
Note: Windows NT 4.0 does not support the Sleep mode
function.
1-26 System Overview
A
A Fan module 0
B Fan module 1
Figure 1-10 Hot Swap Fan Modules
Information
Fan Module 0
Error Code Fan
0B30 1
0B31 2
0B32 3
Error Code Fan
40h 1
41h 2
42h 3
B
Fan module 1
Error Code Fan
0B33 4
0B34 5
0B35 6
Error Code Fan
43h 4
44h 5
45h 6