Network Problems - Dell E310dw User Manual

The machine prints the first
couple of pages correctly,
then some pages have
missing text.
The machine does not print
on both sides of the paper
even though the printer
driver setting is 2-sided.
Print speed is too slow.
The machine does not feed
paper.
The machine does not feed
paper from the Manual feed
slot.
The machine does not feed
envelopes.

Network Problems

• Error Messages
Your Dell machine will display an error message if an error occurs. The most common error messages are shown
in the chart.
• Where Can I Find My Dell Machine's Network Settings?
• I Cannot Complete the Wireless Network Setup Configuration.
• My Dell Machine is Not Found on the Network During Printer Driver Installation.
• My Dell Machine Cannot Print over the Network.
• My Dell Machine is not Found on the Network Even After Successful Installation.
• My Security Settings are not Working Properly.
• I Want to Check that My Network Devices are Working Correctly.
Check the settings in your application to make sure they are set up to work with your machine.
Your computer is not recognizing the full signal of the machine's input buffer. Make sure you
connected the interface cable correctly.
Check the paper size setting in the printer driver. You must select Letter, Legal or Folio (For US
region. For EU region, select A4) paper that is 16 to 28 lb (60 to 105 g/m
Try changing the printer driver setting. The highest resolution needs longer data processing,
sending and printing time.
If there is paper in the paper tray, make sure it is straight. If the paper is curled, straighten it.
Sometimes it is helpful to remove the paper, turn the stack over and put it back in the paper
tray.
Reduce the amount of paper in the paper tray, and then try again.
Make sure Manual is not selected for Paper Source in the printer driver.
Clean the paper pick-up rollers.
Use both hands to push one sheet of paper firmly into the manual feed slot until the top edge of
the paper presses against the paper feed rollers. Continue pressing the paper against the rollers
until the machine grabs the paper and pulls it in further.
Put only one sheet of paper in the manual feed slot.
Make sure Manual is selected for Paper Source in the printer driver.
Load one envelope at a time in the manual feed slot. Your application must be set to print the
envelope size you are using. This is usually done in the Page Setup or Document Setup menu of
your application.
).
2
Troubleshooting 127