Dell E525w User Manual page 140

Connection No Entry
Status
HOST xxxxxx
Current Role
Current SSID
SSID
PassPhrase Print Passphrase
Reset Passphrase
WPS Method Push Button Configuration*
PIN Code
Reset Wireless
Purpose:
To initialize wireless network settings. After executing this function and rebooting the printer, all wireless network
settings are reset to their default values.
No* Does not reset the wireless setting.
Yes Resets the wireless setting.
NOTE:
This item is available only when the Ethernet cable is disconnected and
TCP/IP
Purpose:
To configure TCP/IP settings. The change takes effect after the printer is turned off and then on.
Values:
IP Mode Dual Stack*
IPv4 Mode
IPv4 Ethernet/ Get IP Address
1
IPv4 Wireless*
IP Address
Subnet Mask
Gateway Address
140
Understanding the Printer Menus
Indicates that no device is available.
Displays the connected device name and current status of the
Wi-Fi Direct network.
Disconnect
Reset Passphrase Disconnect the device and reset passphrase.
Client
Displays the current SSID. Confirm it when you select the
Wi-Fi Direct network on your mobile device.
Specifies a name to identify the wireless network.
Prints the passphrase. Confirm it when you enter the
passphrase to your mobile device.
Cancel
Start
Configures the Wi-Fi Direct network with WPS-PBC.
Configures the Wi-Fi Direct network with PIN code assigned
automatically by the printer.
Uses both IPv4 and IPv6 to set the IP address.
Uses IPv4 to set the IP address.
AutoIP* Automatically sets the IP address.
BOOTP Uses BOOTP to set the IP address.
RARP Uses RARP to set the IP address.
DHCP Uses DHCP to set the IP address.
Panel Manually sets the IP address on the operator panel.
Manually sets the IP address allocated to the printer.
Manually sets the subnet mask.
Manually sets the gateway address.
Disconnect the device.
Displays the current group role of the
printer
is set to .
Wi-Fi On