Configuring Fax Initial Settings - Dell E525w User Manual

Color multifunction printer
Hide thumbs Also See for E525w:
Table of Contents

Advertisement

Faxing
NOTE:
If the Function Enabled setting for
fax function. If the Function Enabled setting for
Enabled" on page 158.
NOTE:
A password is required to enter
password you specified, and press the
NOTE:
Ensure that the telephone line is connected properly. For details, see "Connecting the Telephone Line" on page 35.

Configuring Fax Initial Settings

NOTE:
The following settings can be configured also using Advance Tools on Easy Setup Navigator.
Setting Your Country
You need to set the country where your printer is used for using the fax service on the printer.
1 Press the
(Menu) button.
2 Press the
button until System is highlighted, and then press the
3 Press the
button until Admin Menu is highlighted, and then press the
4 Press the
button until Fax Settings is highlighted, and then press the
5 Press the
button until Country is highlighted, and then press the
6 Press the
button to select the country where the printer is used, and then press the
7 Ensure that Are You Sure? is displayed, press the
button.
The printer restarts automatically to apply the settings.
NOTE:
In case of either one, when you configure the country setting, the information, which is registered to the device, is
initialized.
Setting the Printer ID
In most countries, you are required by law to indicate your fax number on any fax you send. The printer ID,
containing your telephone number and name or company name, will be printed at the top of each page sent from
your printer.
1 Press the
(Menu) button.
2 Press the
button until System is highlighted, and then press the
3 Press the
button until Admin Menu is highlighted, and then press the
4 Press the
button until Fax Settings is highlighted, and then press the
5 Press the
button until Fax Number is highlighted, and then press the
6 Enter your fax number using the number keypad.
NOTE:
If you make a mistake while entering numbers, press the
7 Press the
(Set) button when the number on the display is correct.
8 Press the
button until Fax Header Name is highlighted, and then press the
9 Enter your name or company name using the numeric keypad.
is set to
FAX
On(Password)
is set to
, the fax function is disabled. For details, see "Function
FAX
Off
when
Admin Menu
Panel Lock Set
(Set) button.
button to select Yes, and then press the
, you need to enter the four digit password to use the
is set to
. In this case, enter the
Enable
(Set) button.
(Set) button.
(Set) button.
(Set) button.
(Set) button.
(Set) button.
(Set) button.
(Set) button.
(Set) button.
(Backspace) button to delete the last digit.
(Set) button.
20
(Set)
221
Faxing

Hide quick links:

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents