Dell E525w User Manual page 110

1
Certificate Management*
1
Delete All Certificates*
*1
This item is available only when the self-signed certificate has been generated.
*2
This item is effective only when connected via SSL/TLS (https). Only the administrator is allowed to display the pages.
IPsec
Purpose:
To specify the Security Architecture settings for Internet Protocol (IPsec) for encrypted communication to the
printer.
Values:
IPsec Settings
NOTE:
If IPsec is enabled with incorrect settings, you must disable it using the IPsec menu on the operator panel.
110
Dell™ Printer Configuration Web Tool
Click to display the Certificate Management page and to manage a security certification from the
page.
Category
Issued To
Issuer
Serial Number
Public Key Method
Public Key Size
Valid From
Valid Until
Status
Certificate Purpose
Certificate Selection Status Displays the type of device certificate.
Delete
Click to delete all the certificates.
Protocol
IKE Authentication Method Displays the type of authentication method used for IPsec.
Pre-Shared Key
Re-enter Pre-Shared Key
IKE SA Lifetime
IPsec SA Lifetime
DH Group
PFS
Remote peers IPv4 address
Remote peers IPv6 address
Non IPsec communication
policy
Displays the device to certificate.
Displays the device to certificate.
Displays the issuer to certificate.
Displays the serial number of the device.
Displays the public key method.
Displays the size of public key.
Displays the time the certificate is valid.
Displays the time the certificate is invalid.
Displays whether certificate is valid or not.
Displays the purpose of certificate.
Click to delete this certificate.
Select the check box to enable the protocol.
Sets a shared key. Up to 255 alphanumeric characters, periods, and
hyphens can be used.
Enters the shared key again to confirm it.
Sets the lifetime for IKE SA from 5 to 28,800 minutes.
Sets the lifetime for IPsec SA from 5 to 2,880 minutes.
Sets the DH group.
Select the check box to enable the PFS setting.
Sets the IP address to connect to.
Sets the IP address to connect to.
Allows communication with a device which does not support IPsec.