Clean The Hopper Rollers; Prepare The Printer For Use - DataCard CD800 User Manual

Clean the Hopper Rollers

1.
Access the LCD menu system and enter the Cleaning Card
menu.
2.
Select the hoppers for cleaning.
a.
Press the down arrow key until Hopper displays on line 2
of the LCD panel.
b.
Press E
c.
Press the down arrow key and choose All to clean
hoppers H1, H3, H4, H5, and H6. (Or, continue pressing
down to select hoppers 1 through 6 to clean a hopper
individually.)
3.
Press E
NTER
The printer moves the cleaning cards back and forth across the hopper rollers several times
and then ejects the cleaning cards back into the hoppers.
The printer returns to Ready when the cleaning cycle completes.
To complete the cleaning process, continue with "Prepare the Printer for Use".

Prepare the Printer for Use

1.
Unlock the printer and open the multi‐hopper door.
2.
Remove the used cleaning cards from the hoppers.
3.
Replace the unprinted cards in the input hoppers.
4.
Open the printer supplies access door and the printer
cover. Remove the print ribbon cartridge.
5.
Install a new cleaning sleeve on the ribbon cartridge
and remove the protective cover. Refer to "Load the
Cleaning Sleeve" on page
6.
Replace the ribbon cartridge.
7.
Close the printer cover. Press down on the ridges on
the front of the cover to latch it properly.
8.
Close the printer supplies access door.
9.
Open the reject card tray and remove the used cleaning card.
CD800 Card Printer User's Guide
to enter the Hopper menu.
NTER
to start the cleaning process.
25 for the steps to follow.
37