Table of Contents
Advertisement
1. Position the thermal switch assembly with the wires facing you. Align the slots in the bracket with the
two (2) 5/16" hex head screws on the underside of combustion chamber. These screws may need to be
loosened in order to slip the bracket in between the heads of the screws and the underside of the
combustion chamber. Tighten the screws until they are snug
2. Slide the 1/2" flange of the mesh guard under the two (2) clips on the bottom of the unit and underneath
the thermal switch assembly.
3. Attach the bare end of the green/yellow ground wire to the grounding screw located inside the junction
box.
4. Plug the white rectangular connector to its mate inside the junction box (the connector inside the box
will first have to have the empty plug side discarded).
5. Insert the speed control shaft through the opening in the control panel. Secure the speed control with
the hexagonal nut supplied with this kit. Attach the knob to the speed control. (North America Only)
6. Reinstall the bottom fireplace trim in the reverse order (see #2).
7. Reinstall the lower grille in the reverse order (see #1).
5.3.2 Operation (North America Only)
5. Turn the control knob clockwise to turn the fan
6. Adjust the control knob clockwise for
7. Turn the control knob fully counter-clockwise to turn the fan
: The fan will not operate until the stove warms up (approximately 12-15 minutes).
N
OTE
O
speed or counter-clockwise for
L
OWER
Figure 5.7 - Fan and Thermal Switch Wiring
(D
N
O
O
OT
.
N
.
O
FF
-
).
VER
TIGHTEN
speed.
H
IGHER
/29
Advertisement
Table of Contents
