Accessories; Porcelainized Combustion Chamber Panels; Installation; Figure 5.1 Installation Of Left And Right Porcelain Panels - Osburn Designer DV36 Installation And Operation Instructions Manual

Built-in direct vent gas fireplace designer series

Table of Contents

5. Accessories

For installations where the Porcelainized panels are to be fitted into the combustion chamber, the following

installation and cleaning instructions are recommended.

1. Follow the service instructions in Section 4.4 that describe the step by step procedure to remove the

burner and logset from the combustion chamber. This must be done in advance of the panel installation.

Set the burner and log set aside and out of any traffic areas to avoid damage to the log set.

2. Position the bottom tabs of the left and right side panels into the slots on the bottom of the combustion

chamber, and rotate each into the upright position. Push the panels towards the rear of the unit, making

sure to capture the inside lip of the front of each panel with the two screw heads located on each of the

combustion chamber sides (see Figure 5.1). There are two slots in each panel that should fit snuggly

underneath the screw heads. These screws may need to be adjusted in order that the panels are properly

secured.

/25

Table of Contents