Windhager DuoWIN Assembly Instructions Manual page 62

3. For the Electrician
All electrical connections are located in the control panel Wood gasification boiler . The control panel at the front
contains the LogWIN main board while the control panel at the rear contains the connection terminals (screwless
spring-type terminals) for connecting the MESplus control.
– Remove rear boiler cover (Fig. 155), loosen 2 screws from front boiler cover (Fig. 156) and lift up cover and pull
off to the rear – Fig. 157.
Fig. 155 Removing the rear boiler cover
Fig. 157 Lifting boiler cover and pulling off
to the rear
– Check 4-pin plug on InfoWIN
connect and route in side panel – Fig. 158.
PLUS
InfoWIN
cable
Fig. 158 Connect InfoWIN
PLUS
cable, route to left side from control panel as necessary (see also 2.4.21),
PLUS
cable if necessary and route in side panel
Fig. 156 Loosen 2 screws
62