Windhager DuoWIN Assembly Instructions Manual page 32

2. For the Installer
– Route both cables from the air control upward in the side panels via the cable channel feed-through into the
control panel, as shown in Fig. 53. Connect as shown in Fig. 54.
– Route the lambda sensor cable from the control panel downward via the cable channel feed-through in the side
panel, and connect to the lambda sensor – Fig. 53.
Cable duct
Low voltage
(230 V AC)
Air control
Air control cable with
Plug X6/X7
Fig. 53 Wood gasification boiler with rear panels removed – rear view
Fig. 54 Wood gasification boiler control panel – top view
32
Cable duct
Extra-low voltage
(0 – 12 VDC)
Air control cable with
Plug X14
Lambda sensor cable Lam
Plug to Plu
lam lambda sensor
Air control cable with Plug
X6/X7
Air control cable with Plug
X14 X14
Flue gas sensor
(accessories) Plug X11