End Cover
Model
CJ1W-TER101
*1 One End Cover is provided with the CPU Unit and with an I/O Interface Unit.
Others
Name
DIN Track
Programming Device Connecting
Cable for peripheral (USB) port
Programming Device Connecting
Cables for serial port
Connecting Cable for EtherNet/IP
port
CJ2 CPU Unit Hardware User's Manual
Specifications
Must be connected to the right end of the CPU Rack. (A
fatal error will occur if the End Cover is not connected to
*1
the right end of the Rack.)
Model
PFP-50N
PFP-100N
PFP-100N2
PFP-M
Commercially available
USB cable
XW2Z-200S-CV
XW2Z-500S-CV
XW2Z-200S-V
XW2Z-500S-V
Commercially available
100Base-TX twisted-
pair cable
2 Basic System Configuration and Devices
Current con-
sumption (A)
Included with
CPU Unit and I/O
Interface Unit.
Specifications
Track length: 50 cm, height: 7.3 mm
Track length: 1 m, height: 7.3 mm
Track length: 1 m, height: 16 mm
Stopper to prevent Units from moving on the track.
Two each are provided with the CPU Unit and with
an I/O Interface Unit.
USB 2.0 (or 1.1) cable (A connector - B connec-
tor), 5.0 m max.
Connects to IBM PC/AT computer
D-Sub 9-pin connector (Cable length: 2.0 m).
Uses static-resistant connector.
Connects to IBM PC/AT computer
D-Sub 9-pin connector (Cable length: 5.0 m).
Uses static-resistant connector.
Connects to IBM PC/AT computer
D-Sub 9-pin connector. (Cable length: 2.0 m)
Connects to IBM PC/AT computer
D-Sub 9-pin connector. (Cable length: 5.0 m)
Recommended: Fujikura F-LINK-E 0.5 mm × 4P
Twisted-pair cable with RJ45 Modular Connectors
on both ends. Connect between EtherNet/IP Unit
or built-in EtherNet/IP port and switching hub.
Use STP (shielded twisted-pair) cable of category
5 or 5e.
Weight
---
2
*1
*1
2-5