Back - Otto Bock Skippi Service Manual

Lap Belt
The lap belt of the Skippi is/must be attached to the bearing plate. For attachment, an attach-
ment plate with eyelet is used. The mounting kit of the lap belt also includes spacer bushings.
Place these bushings between the eyelet and bearing plate. For tightening the screw use a
5 mm Allen wrench and a 13 mm open-end wrench.
Attaching the lap belt

6.5 Back

The back of the Skippi is attached to the seat frame with two bearing plates on the left and
right. Each of the two bearing plates is attached to the seat frame with two screws and to the
back with one screw. For loosening these three screws use a 5 mm Allen wrench and a 13 mm
open-end wrench. Loosen the two screws on the seat frame on the left and right to remove the
back. The fourth screw on the bearing plate serves as stop for the back angle adjustment.
Loosening the bearing plate
21