Extending Module Connection - 2N Helios IP Verso Installation Manual

2.3 Extending Module Connection

Module Bus Interconnection
All the
interconnected via a bus. The bus starts on the basic unit and goes over all the
modules. The order of modules on the bus is irrelevant. And it also irrelevant which bus
connector on the module is used as the input and which is used as the output.
The modules include a 220 mm long interconnecting cable; the Wiegand (9155037)
and I/O modules (9155034) include an 80 mm long interconnecting cable.
You can order a separate 1 m long bus cable (9155050) for remote installation of the
®
2N Helios IP Verso
opposite side of the wall on which the
The modules can be combined in each base as follows:
Module
Infopanel
Keypad
RFID card
reader, 125
kHz
RFID card
reader, 13
MHz
I/O module
5-button
module
Electronic
buttons
Wiegand
module
Tamper
switch
Blank
module
Infopanel Module
The Infopanel module is one of the
used for inserting and backlighting printed information.
The module contains two
These two connectors are fully interchangeable and can be used both as inputs
from the basic unit and outputs to other modules.
If this module is the last one on the bus, one of the connectors remains
unconnected.
The module package includes a 220 mm long interconnecting cable.
®
2N TELEKOMUNIKACE a.s., www.2n.cz
®
2N Helios IP Verso
modules. Typically, it helps install an RFID card reader on the
Externally
mounted (visible
module)
X
X
X
X
X
X
X
modules, except for the Tamper Switch, are
®
2N Helios IP Verso
Internally mounted
(invisible module)
X
X
®
2N Helios IP Verso
®
2N Helios IP Verso
intercom is installed.
Internally mounted on
the bottom base edge
X
intercom elements and is
bus connectors.
86