Enabling Autopilot Control - Raymarine a series Installation Instructions Manual

6.16 Enabling autopilot control

Enabling the autopilot control function —
SeaTalk and SPX SeaTalk
To enable control of your SeaTalk or SPX SeaTalk
autopilot using your multifunction display follow the
steps below.
From the Homescreen:
1. Select Set-up.
2. Select System Settings.
3. Select Autopilot Control so that On is
highlighted.
Selecting Autopilot Control will switch the control
between On and Off.
On a system containing multiple displays the pilot
control is enabled on all displays at the same time.
Enabling the autopilot control function —
Evolution autopilots
To enable control of your Evolution autopilot using
your multifunction display follow the steps below.
From the Homescreen.
1. Select Set-up.
2. Select System Settings.
3. Select External Devices.
4. Select Pilot Set-up.
5. Select Pilot control so that On is highlighted.
Selecting Pilot control will switch the Autopilot
control function on and off.
Getting started
ng autopilots
ng
87