Thermal Camera Connection - Raymarine a series Installation Instructions Manual

Important: If your IP camera(s) are not detected
by your multifunction display, try power cycling
the IP camera(s) whilst leaving your multifunction
display powered up.
For further information regarding camera installation
(including power connection and mounting), refer to
the installation instructions supplied with the camera.
IP camera guidance
Raymarine ® MFDs are capable of displaying IP
camera feeds. Whilst third-party IP cameras may
work, Raymarine ® highly recommends only using
Raymarine ® IP cameras such as the CAM200IP.
As guidance any third-party IP camera must conform
to the following:
• The camera must support H.264 compression and
RTSP (Real time Streaming Protocol).
• The camera must be ONVIF compliant
• The camera must be capable of and be setup to
allow unauthenticated anonymous access
• The camera must be capable of and be setup to
assign an IP address automatically via DHCP
• The camera resolution must be set to no higher
than 720p
The camera settings must be checked and if
necessary adjusted using a PC and the software
supplied with the camera, prior to adding the camera
to the SeaTalk hs network.
Important: Raymarine
compatibility with third-party IP cameras.
54
® does not guarantee

4.22 Thermal camera connection

Thermal cameras can be connected directly to the
display's network connection or can be connected to
the SeaTalk hs network, via a Raymarine
switch.
2 connections are required:
• Network connection — required to control the
thermal camera via a compatible Raymarine
MFD or optional Joystick Control Unit (JCU).
• Video connection — transmits the composite
video signal to a compatible Raymarine
Note: The Thermal camera can only be connected
to MFDs with a Video input connection.
T200 Series connection
1. MFD
2. Thermal camera
3. Power over Ethernet (PoE) Injector
4. RayNet to RJ45 SeaTalk
5. Network connection to MFD (RayNet)
6. Video connection to MFD (composite video)
7. Video cable
T300 / T400 Series connection.
2 3
SeaT alk
5
8
1. MFD
2. Video connection to MFD (composite video)
3. Network connection to MFD (RayNet cable)
a Series / c Series / e Series installation instructions
® network
® MFD.
1
4 5
hs adaptor cable
1
4
hs
/ RayNet
6
hs
SeaT alk / RayNet
7
9
10
hs
SeaT alk / RayNet
®
6
7
D12839-2
D12260-2