Temporary Disabling Of Demi Water - On Gw Series Only - Smeg GW1160 User Manual

4.11 TEMPORARY DISABLING OF DEMI WATER - ON GW SERIES ONLY

Press the "Start/Stop" and "Door opening" buttons simultaneously for a moment to display the
status of the "demineralised water disabling" option.
The Selection buttons can be used to deselect the use of demineralised water.
No further confirmation is required to activate the modification of this parameter.
Whenever the option is active, the message "no dE ", meaning "No demi" (temporary disabling of demineralised
water), appears on the display for 3 seconds.
If the option is disabled by pressing the two keys mentioned above, the message "dE" is shown on the screen for 3
seconds.
This option can only be used if the use of demineralised water has been activated.
(See parameter "7-Demineralised water" below in the setup parameters section, in the: SETUP MODE - "FUNCTIONS")
(This option can only be used on GW models and not on WD models.)
The disabling option can be activated before starting the selected program, and remains active
for only one cycle, at the end of which it is deactivated automatically.
When the disabling option is active, demi water is replaced with cold water in all the phases where
it would normally be used.
1
fig. 19 – Demi water disabling buttons. To access the function: hold down the Functions + Door opening buttons together. To select demi water
fig. 20 – Display screen: TEMPORARY disabling of demi water; the option can be enabled and disabled using the selection buttons
User Manual
disabling: Selection buttons
GW1160 - GW4060 Series
2
Page 31 - 75
1