Setup Mode - "Functions; Accessing The Setup Mode / Entering The Password - Smeg GW1160 User Manual

5 SETUP MODE - "FUNCTIONS"

The appliance has setup procedures for modifying its operating parameters.
The setup mode can be accessed by pressing the "Functions" button and requires a password.
For reasons of security and responsibility, 4 levels of password are available to access different levels of functions and
settings::
1. USER Level (1111)
2. SUPERUSER Level (provided by the installation engineer)
3. ENGINEER Level
4. SMEG Level
5.1

ACCESSING THE SETUP MODE / ENTERING THE PASSWORD

a. Hold the Functions button (5) down for 5 seconds. 4 dashes appear on the display.
b. Use the Selection buttons (4-8) to modify the individual characters of the password.
c. Short press the Functions button (5) to move on to the next character
d. Once the 4 characters of the password have been entered, confirm by holding down the Start/Stop button (3).
a. If the password entered is correct, the system accesses the first menu item
b. If the password is not correct, two beeps signal the error.
c. 5 seconds after the last button is pressed, the system automatically quits the Setup menu.
e. Once the Setup mode has been accessed, the various items available can be scrolled using the Functions button
(5).
f. Note on GW4060 series: a short press on the button Drying + (6) has the same meaning of the short press on
button Functions (5) in the following cases:
a. When entering password, to switch from one character to the next.
b. Going into the setup mode, to scroll through the various items available.
4
The items accessible from the SETUP menu are shown in the table below. To move on from one item to the next,
press the "Drying" button.
Setup Item
Set
Cloc
User Manual
fig. 24 – Functions button: hold down to access the Setup mode.
Description
Appliance parameter setup - detailed explanation provided below in "Set" Parameters
Date and time - detailed explanation provided below in "Cloc" Parameters
GW1160 - GW4060 Series Page 34 - 75