Table of Contents
Advertisement
Starting up the system
The configuration label shows you the equipment included in your
BEETLE /60 POS system. A sample is contained in the Appendix (page
GB-97). The label is located on the cover panel of the lower POS housing.
The data specified on this label is required when entering the
setup parameters (see setup).
Start and runup behavior
After installing the BEETLE, switch on the POS system by means of the
power switch on the back of the housing.
The system first performs an automatic self-test to test its basic functions.
The following message appears for example on the four-line cashier
display or the monitor:
* xx/xx is the placeholder for the version number
The system then determines the medium from which the operating system
and POS application are to be booted. Each medium is assigned a logical
drive according to the configuration of your BEETLE POS system.
WN ID xx/xx* Date
GB - 67
Advertisement
Table of Contents
