Table of Contents
Advertisement
Starting up the system
The configuration label shows you the equipment included in your modular
BEETLE /M-II plus system.
The label is located at the underside of the BEETLE /M-II plus. The data
specified there are required for entering the setup parameters (see section
BIOS Setup in the manual "BEETLE POS Motherboard, F2-CPU").
Start and runup behaviour
After installing the BEETLE /M-II plus, switch on the POS system using the
ON/OFF button on the front panel and the power switch on the power
supply.
The system first performs an automatic self-test to test its basic functions.
For example, you may see the following message (irrespective of processor
type) on the four-line cashier display or on the monitor:
xx/xx is the placeholder of the BIOS version number.
The system then determines the medium from which the operating system
and POS application are to be booted. Each medium is assigned a logical
drive according to the configuration of your BEETLE /M-II plus.
The following media can be assigned a drive:
Network
Hard disk
CD-ROM
34
WN ID xx/xx Da tum
BEETLE /S-II plus
Advertisement
Table of Contents
