Table of Contents
Advertisement
START AND RUNUP BEHAVIOUR
Starting up the system
The configuration label shows you the equipment included in your modular
BEETLE /S system.
The label is located on the underside of the BEETLE /S. The data specified
there are required for entering the setup parameters (see "Setup" in the
manual BEETLE POS Motherboard).
Start and runup behaviour
After installing the BEETLE /S, switch on the POS system on the rear side
and then press the ON/OFF button on the front panel.
The system first performs an automatic self-test to test its basic functions.
For example, you may see the following message (irrespective of processor
type) on the four-line cashier display or on the monitor:
xx/xx is the place holder of the BIOS version number
The system then determines the medium from which the operating system
and POS application are to be booted. Each medium is assigned a logical
drive according to the configuration of your BEETLE /S.
The following media can be assigned a drive:
Starting up the system
Disk
Network
Hard disk
Flash disk
CD-ROM
30
WN ID xx/xx Date
Advertisement
Table of Contents
