Starting Up The System - Wincor Nixdorf BEETLE /iPOS plus Advanced User Manual

Starting Up the System

After installing the BEETLE /iPOS plus Advanced, switch on the system by
using the Power button on the front panel.
The system first performs an automatic self-test to test its basic functions.
For example, you may see the following message (irrespective of processor
type) on the monitor:
WN „ID xx/xx Date"
xx/xx is the placeholder of the BIOS version number.
The system then determines the medium from which the operating system
and the application are to be booted. Each medium is assigned a logical
drive according to the configuration of your BEETLE /iPOS plus Advanced.
The following media can be assigned a drive:

Network

Hard disk drive/solid state drive

USB drive
The logical drives are designated C: and D:.
The network is always assigned to the C: drive during the runup procedure.
The hard disk can be assigned to the C: or D: drive. The system can only be
started from the hard disk if the disk has been configured as the C: drive.
Corresponding to the Setup configuration the modular BEETLE /iPOS plus
Advanced can be booted from the following drives:

Hard disk drive C:

LAN module with BOOTPROM

USB drive
BEETLE /iPOS plus Advanced User Manual 55