Procedure 1 Touch Pad Connection Check; Procedure 2 Touch Pad Replacement Check - Compal JHT01 Service Manual

JHT01 Service Manual
To determine if the computer's built-in Touch Pad is functioning properly,
perform the following procedures. Figure 6-8 outlines the process. Start with
Procedure 1 and continue as instructed.
• Procedure 1:
• Procedure 2:
9.1 Procedure 1
The Touch Pad is connected by the Touch Pad FPC to the system board. Make
sure the Touch Pad FPC cable is firmly connected to the Touch Pad and system
board. Replacement Procedures for instructions on how to disassemble the
computer and then perform the following checks.
If any of the connections are loose, reconnect firmly. If any of the connections is
damaged, or there is still an error, go to Procedure 2.
9.2 Procedure 2
The Touch Pad unit or FPC may be defective or damaged.
6-22
Touch Pad connection check
Touch Pad replacement check
Touch Pad connection check
Touch Pad replacement check