Channel Audio Kit Installation - IEI Technology PICOe-9452 User Manual

5.6.3 5.1 Channel Audio Kit Installation

NOTE:
This is an optional item that must be ordered separately. For further
information please contact the nearest PICOe-9452 distributor, reseller
or vendor or contact an iEi sales representative directly. Send any
queries to sales@iei.com.tw.
The optional 5.1 channel audio kit connects to the 10-pin audio connector on the
PICOe-9452. The audio kit consists of three audio jacks. One audio jack, Mic In, connects
to a microphone. The remaining two audio jacks, Line-In and Line-Out, connect to two
speakers. To install the audio kit, please refer to the steps below:
Step 1: Connect the audio kit cable. The audio kit is shipped with a cable that
connects the audio kit to the PICOe-9452. Connect the cable to the connector
on the back of the audio kit. Make sure the pins are properly aligned (i.e. pin 1
connects to pin 1).
Step 2: Locate the audio connector. The location of the 10-pin audio connector is
shown in Chapter 3.
Step 3: Align pin 1. Align pin 1 on the onboard connector with pin 1 on the audio kit
cable connector. Pin 1 on the audio kit cable connector is indicated with a white
dot. See Figure 5-14.
Page 96
PICOe-9452 Half-size CPU Card