Table of Contents
Advertisement
PICOe-9452 Half-size CPU Card
5.6.7 Dual RS-232 Cable with Slot Bracket
The dual RS-232 cable slot connector consists of two connectors attached to two
independent cables. Each cable is then attached to a D-sub 9 male connector that is
mounted onto a slot. To install the dual RS-232 cable, please follow the steps below.
Step 1:
Locate the connectors. The locations of the RS-232 connectors are shown in
Chapter 3.
Step 2:
Insert the cable connectors. Insert one connector into each serial port box
headers. See Figure 5-20. A key on the front of the cable connectors ensures
the connector can only be installed in one direction.
Figure 5-20: Dual RS-232 Cable Installation
Step 3:
Secure the bracket. The dual RS-232 connector has two D-sub 9 male
connectors secured on a bracket. To secure the bracket to the chassis please
refer to the reference material that came with the
chassisStep 0:
Page 103
Advertisement
Table of Contents
