Table of Contents
Advertisement
Some optional items that can be purchased separately and installed on the
PICOe-PV-D510 include:
SATA power cable
Parallel port cable
7.1 channel audio kit
4.7.2 7.1 Channel Audio Kit Installation
NOTE:
This is an optional item that must be ordered separately. For further
information please contact the nearest PICOe-PV-D510 distributor,
reseller or vendor or contact an iEi sales representative directly. Send
any queries to sales@iei.com.tw.
The optional 7.1 channel audio kit connects to the 10-pin audio connector on the
PICOe-PV-D510. The audio kit consists of five audio jacks. One audio jack, Mic In,
connects to a microphone. The remaining four audio jacks, Line-In, Front-Out, Rear-Out,
and Center Subwoofer, connect to speakers. To install the audio kit, please refer to the
steps below:
Step 4:
Connect the audio kit cable. The audio kit is shipped with a cable that
connects the audio kit to the PICOe-PV-D510. Connect the cable to the
connector on the back of the audio kit. Make sure the pins are properly aligned
(i.e. pin 1 connects to pin 1).
Step 5:
Locate the audio connector. The location of the 10-pin audio connector is
shown in Chapter 3.
Step 6:
Align pin 1. Align pin 1 on the on-board connector with pin 1 on the audio kit
cable connector. Pin 1 on the audio kit cable connector is indicated with a white
dot. See Figure 4-8.
Page 52
PICOe-PV-D510 User Manual
Advertisement
Table of Contents
