Table of Contents
Advertisement
Call ending alert
Relay activation signal
Programming enter by phone
Programming by phone
Parameter confirmation
Programming enter by PC
Line connection (Reset)
Error (generally all incorrect)
Memory empty (no number
programmed)
For the problems identification is very good when you know the tones. It helps you monitor how door
intercom works and where from comes the problem. The signaling might be switch of in a few levels
(Parameters 61,62,63 and 65).
4.2. Visitor at the door
When the visitor finds the desired name and push it, the Link Ana iDP pick up the line and play the tone
line pick up (when is not switch off by parameter 62) and calls the phone number saved under the
button (parameter 1). On the Link Ana iDP speaker you hear ringing tone and the destination phone
ringing.
As soon as the destination phone pick up, you can talk to visitor at the door.
When is electrical lock is connected to the Link Ana iDP, you can open the door for visitor by dial DTMF
code on the destination phone.
When the destination phone hang-up the line then the Link Ana iDP hangs up after busy tone detection.
When the call duration is longer then setup limit (parameter 52) 10 sec before hang up, the Link Ana
iDP sends a alerting tone of call ending, dial * or # (parameter 42) to prolong the call.
The dialed number is dictated by the chosen mode, which is set in the unit (parameter 47):
Day/Night mode: If the unit is in Day mode, it will always dial the number set in parameter 1,
•
In Night mode, it will always dial the number set in parameter 2. The mode switchover is set in
parameters 45,46.
2 groups numbers mode: On the first press the number set in parameter 1 will be dialed. When
•
the same button is pushed or 10 seconds after dial busy tone is detected, or setup number of
rings is out (parameter 56), the unit will select the number from the second group (parameter 2).
The next press of the same button again selects the number from the first group, etc....
When visitor push the button after line is picked up the Link Ana iDP hangs up for time setup by
parameter 54 and then picks up the line and dial new number. The dialing number is either by tone dial
(DTMF) or pulse dial up setting by parameter 41. There is one more option: the line hangs up by again
pushing of same button (parameter 4*).
4.3. Relays mode control
You can control relay(s) by door intercom buttons (code lock). When visitor push buttons in order which
match to setup code (Parameter 32-34) and time between each button press is not longer than setup by
(Parameter 53) then door intercom picks up and activate appropriate relay (when relay setup is mode
m=1 or m=5) for time setup by Parameter 37 eventually.39,30. Then hangs up.
The relay (up control code) can activate one pulse or two pulses with time between each pulse setup by
Parameter 30 :
p.8 | 23
1333
–■–■–■–
─▒▒▒▒▒▒─
Modulated
980-1067-1180
–▄■▀–
Modulated
––▓–▓–––––
800
––█––
980-1067-1180
–▄■▀–
1850-1067-1850
–■–▄–■–
800
–■–■–■–■–■–■–
1300-2100
–▄■▄■▄■▄■–
Advertisement
Table of Contents
