Table of Contents
Advertisement
Parameter Value
67
By activation this feature (b=1) is cancelled acoustic signaling of empty memory. After pushing of button
with empty memory you get just beep (confirmation) and call is established as normal dialed number
Caution: first 10sec of call is not active tone detector (it waits on reaction of PBX and number dialing by
PBX)
Paramet
Valu
er
e
68
b
Default is off m = 0 By enabling the m = 1 mutes the acoustic path at close relay (1 or 2) in "electric lock"
(modes 1 and 5). This feature is there because if you often use code lock function or exit button, so the
switch-on time to hear the tone exchange. For some customers, this can be distracting.
Parameter Value
6*
In default is switch off t=0. By activation this feature t=1 is processor going to „sleep mode" after line
connection and after 3sec the door intercom makes initialization. It delays line picks up after line (voltage)
connection – activation status / PBX restart. When this feature is not efficient and PBX still evaluate the
line into „failure" mode" then you have to use external power supply – put DIP switch 3 and 4 to position
"on". It is the same like using Best Box option.
6.6. Hands Free Parameters setting
Parameter Value
71
72
73
gg / ff / rr – 2 digits in range [01-16]
After reception of confirmation, the new value is active and you can test it.
Help: you can also add / decrease the amplification with the phone buttons:
*
-
#
and
=
=
The Limits of maximal and minimal loudness are acoustically signaling by 3 tones. When you don't press
any digit during 5 seconds, the setup value is saved and you hear confirmation tone.
p.20 | 23
Description
BabyCall – call without necessity program
b
phone number
(0/1)
Meaning
Mute at the lock activated
( / )
Description
Delay of line connection (Siemens pbx)
t
(0/1)
Description
Reception loudness (01-16)
gg
(TRH)
Transmission loudness (01-16)
ff
(MIC)
Speaker loudness (01-16)
rr
(SPK)
+.
Default
0
Basic
0
Default
0
Default
07
07
07
Advertisement
Table of Contents
