Time Parameters - Linkcom Link Ana iDP Manual

Parameter Value
43 g bb
g – command order [1-2] (they are two to be possibility hang up the Link Ana iDP when each relay is
used)
bb – command to and call by phone [2 digits]
It is profitable setup the same command to hang up the Link Ana iDP as same as activate relay
(Parameter 35)
Note: The command has always 2 digits but if you want use 1 digit then you have possibility insert "*a"
where a is just one number.
Parameter Value
44 xxxx
xxxx – service password for entry to programming by phone (DTMF)
Parameter Value
45
46
dd – command to switch into DAY mode [2 digits]
nn – command to switch into NIGHT mode [2 digits]
Note. The switchover to Day/Night mode remains set in unit even after line disconnection.
Parameter Value
47
e – operating mode of unit
e=0 for 2 Group mode, e=1 for Day/Night mode.
Parameter Value
4*
k – line hanging up by push of same button:
k=0 feature is switch off
k=1 again button push hang up the line

6.4. Time parameters

Parameter Value
51
q – number of incoming call rings .
Parameter Value
52
p.16 | 23
Description
End call (00-99,*0-*9)
Description
Service password (0000-9999)
Description
Day mode switching
dd
(00-99,*0-*9)
Night mode switching
nn
(00-99,*0-*9)
Description
e
Dialing mode (0/1)
Description
End call by push again the same button
k
(0/1)
Description
q
Number of rings before picks up (1-9)
Description
d
Maximal call duration (0-9,*,#)
Default
155
Default
0000
Default
11
10
Default
1
Default
1
Default
2
Default
2