Handsfree Parameteres Setting - Linkcom link smile User Manual

By activation this feature (b=1) is cancelled acoustic signaling of empty memory. After pushing of button
with empty memory you get just beep (confirmation) and call is established as normal dialed number
Caution: first 10sec of call is not active tone detector (it waits on reaction of PBX and number dialing by
PBX)
Parameter Value
6* t
Sets a delay for line pick-up (OFF HOOK) for new PBX types (particularly Siemens):
t=1 – standard operation
t=0 – delayed start

5.6. HandsFree Parameteres setting

Parameter Value
71 gg
72 ff
73 rr
gg / ff / rr – 2 digits in range [01-16]
After reception of confirmation, the new value is active and you can test it.
Help: you can also add / decrease the amplification with the phone buttons:
* - # +.
and
= =
The Limits of maximal and minimal loudness are acoustically signaling by 3 tones. When you don't press
any digit during 5 seconds, the setup value is saved and you hear confirmation tone.
Parameter Value
74 c
It is going about character of on line operation semiduplex switching. In case where character of
depressed is too steep you can make it softer by c=1.
Parameter Value
75 n
Linkcom France
11 rue du Soleil Levant 92140 CLAMART
Description
Delay of line connection (Siemens pbx)
(0/1)
Description
Reception loudness (01-16)
(TRH)
Transmission loudness (01-16)
(MIC)
Speaker loudness (01-16)
(SPK)
Description
Soft pass of switching (0/1)
Description
Depression of background sound
Default
0
Default
07
07
07
Default
0
Default
(0/1) 0
Copyright © 2011 – Linkcom – All rights reserved
16