Main Parts And Connections; Lifting The Equipment; Filler Wire Materials And Equipment; Filler Wires And Wire Feed - Kemppi PROMIG 200 ML Operation Instructions Manual

2.4.2. Main parts and connections

A
B
C
D
G
E
H
Front machine
A Welding voltage (MIG)
B Wire feed speed (MIG) / Wel-
ding current (MMA)
C Main switch
D Control mode
E Flowmeter / regulator for shiel-
ding gas
F Function panel
Connections:
G Control cable of remote control
H Control cable connector for sub-
feeder / motorized gun
I Welding gun cable
Inside
A Selection of air/liquid cooling
B Wire reel locking
C Wire inch
D Gas test
E Tightening screw
F Feed roll

2.5. Lifting the equipment

For transferring the equipment or a part of it, use the machine handles. Machines can
be lifted with ropes. Fasten the ropes carefully round the machine. Note! Check that the
machine can not move vertically between the ropes.

2.6. Filler wire materials and equipment

2.6.1. Filler wires and wire feed

Choose contact tube, wire conduit and feed roll according to welding wire. Filler wires
and the corresponding wire feed equipment are presented in the following scheme. The
factory assembly includes feed rolls with plain groove and with orange wire guide tubes
for welding fi ller wires of 0.9-1.2 mm (0.035", 0.045" and 0.052").
© KEMPPI OY
F
I
Back side
Connections:
J Control cable to power source
K Shielding gas hose (snap connector)
L Welding current cable
M Connection for MMA
D C
J
K
L
M
E F A B
PROMIG 200ML/0509 – 5