Pairing The It500 System Units For The First Time - Salus iT500 Instruction Manual

Pairing the iT500 System Units for the First Time

Once the iT500 Thermostat and the iT500RX Receiver are physically installed, the two units need to be 'paired' .
Pairing allows the two devices to recognise each other and to communicate wirelessly.
When powering on the iT500TR Thermostat for the first time, the Thermostat will go through the sequence
of screens shown below and automatically try and pair by searching for the strongest signal from an iTG500
Gateway.
The units attempt to pair for 10 minutes and during this time, the icon will flash. Pairing should take
approximately 20 seconds.
OTA (Over the Air) Software All Display Icons
Revision Number
iT500 Software Revision Home Screen
Number
If the pairing is successful, the icon is turned on all the time.
If the pairing fails or times out, the icon will disappear and the system will retry later.
iT500 User Reference Manual
20