Powering On The Axon Hd Server - High End Systems Axon HD User Manual

Powering On the Axon HD Server

WARNING:
This equipment is designed for connection to a branch circuit
having a maximum overload protection of 20 A.
CAUTION:
Do not power on the server until verifying that the line cord
cap is suitable for the power source in your location. For more
information, see Replacing a Power Cord Cap
To power on Axon HD, connect it to an appropriately-rated power source. If the media server
doesn't start, check that the manual power switch behind the right door on the front panel is ON.
Note: To initialize the motherboard graphic card output, one of the Display
Output ports and one of the Server Output ports must have devices
connected when starting the media server. When only one port is
connected, it defaults to display the graphics engine output and will
not display the CMA screen.
Axon HD Media Server User Manual
CHAPTER 2
Setup and Configuration
on page 6
.
11