Powering On The Axon Server - High End Systems AXON User Manual

CHAPTER 2
Setup and Configuration

Powering On the Axon Server

WARNING:
This equipment is designed for connection to a branch circuit
having a maximum overload protection of 20 A.
CAUTION:
Do not power on the fixture until verifying that the line cord
cap is suitable for the power source in your location. For more
information, see Replacing a Power Cord Cap
To power on Axon, connect it to an appropriately-rated power source. If the media server doesn't
start, check that the manual power switch behind the right door on the front panel is ON.
Note: To initialize the graphic card ports, both DVI ports must have devices
connected when starting the media server. When only one port is
connected, it defaults to display the graphics engine output and will not
display the CMA screen.
10
on page 6
.
Axon Media Server User Manual