Elasticity - High End Systems Axon HD User Manual

Elastic Warp Editting
By Default, when editing a Warp Map in the Horizontal, Vertical, or the All Modes, the selection
is based on the position of the mouse if no points are selected. This allows the map to be editing
in a very organic way, that will pull and stretch the influnced area.
Elasticity not applied
Point Selection and Editing
If a control point is selected, in the Horizontal , Vertical , or the All Modes, the modifiction to the
warp map is limited to the selected point(s) If no points are selected, the edit mode will be
based on Mouse position, Distance and Influence. It is possible to switch between single point
edit, group point edit, or eleastic mouse position mode edit. When switching modes, the edits
will follow the editing mode. Multiple points can be selected by using the Shift+Left Mouse
Button. The Elastic mode can be greatly controlled by using the Distance and Influence
parameters.
Export User Mesh
It is possible to create, and edit a warp map in the Warp Editor, and export the map to be used
as a layer object. When Using the Export Mesh button, the file will be placed in the User Warp
directory with a DMX address automatically applied. This warp map can be recalled later to be
edited. Edit will be applied to the files, if you re-export, the file will be over written.
Continous Update (Mouse)
If selected, mouse movements will be seen when editing the warp map. Force Output must be
checked, and the corresponding map must be choosen.
12
Control Point Moved
Elasticity applied
Axon HD CMA Warp Editor