Table of Contents
Advertisement
"RF680M" software
9.6 The functions in the "Extras" menu
● Effect of the settings under "Address" and "Length"
Display in the
editor
Settings under "Auto-Save Filename"
Under "Auto-Save Filename" you can define whether the same file with the same name is
always updated when scanning tags, or whether new files are saved in each case.
Figure 9-19
● "READ.XML"
● "Tag_xxx.XML"
"READ.XML" is set as the default value.
See also
The data editor (Page 56)
9.6.6
Setting the language
You can set the following menu languages for operating the application :
● English
● German
78
If there is no check mark, you can also enter decimal data here. If you subsequently set
the check mark, the data will be converted into hexadecimal format. Depending on the
format setting, the values will be changed in the editor.
You can see from the data editor whether "Hex" or "Dec" is activated; for Hex format, "0x"
is shown for "Address" and "Length":
"Hex" check mark not activated
Auto-Save Filename
If the setting "READ.XML" is selected, the same file READ.XML is always updated each
time tag data is read.
If the setting "Tag_xxx.XML" is selected, a new file with the name TAGxxx.XML is created
each time tag data is read. "xxx" is replaced by the ID of the read tag.
If a tag with the same ID is read again, the corresponding file is overwritten.
"Hex" check mark activated
Operating Instructions, 06/2011, J31069-D0241-U001-A2-7618
SIMATIC RF680M Mobile Reader
Advertisement
Table of Contents
