Adjusting The Acoustic Signal Volume; Set The Backlighting Of The Screen - Siemens SIMATIC RF680M Operating Instructions Manual

5.4.2

Adjusting the acoustic signal volume

The tag functions trigger an acoustic signal indicating whether the operations were
successful or were terminated with an error. You can switch these acoustic
acknowledgements/signals on and off and you can regulate their volume.
Adjusting the volume of the acoustic signals
Press the blue labeled <FN> button in each case to regulate the volume of the acoustic
signals in steps using the "Plus" button (louder) or the "Minus" button (quieter).
Figure 5-4
Specific setting of the acoustic signals
In "Supervisor" mode, select "Start > Settings > Control Panel > Volume & Sounds".
On the "Volume" tab, you can regulate the volume between "Soft" and "Loud" using the bar.
You can also permit or deactivate acoustic signals for different messages by activating the
relevant checkboxes.
5.4.3

Set the backlighting of the screen

To alter the brightness of the display, select "Start > Settings > Control Panel > Display >
Backlight in "Supervisor" mode.
SIMATIC RF680M Mobile Reader
Operating Instructions, 06/2011, J31069-D0241-U001-A2-7618
Keys for regulating the volume
5.4 Basic settings in the operating system
Commissioning
23