Table of Contents
Advertisement
Interface structure of the data editor
User interface
One memory area of the most recently scanned tag is always shown in the editor. In the
drop-down list box [
you check "Complete"
otherwise you can enter values under "Address" [
relevant data area only.
SIMATIC RF680M Mobile Reader
Operating Instructions, 06/2011, J31069-D0241-U001-A2-7618
Item
Description
①
Menu bar
②
Indication of the tag ID
③
Drop-down list box with the transponder-specific memory
areas (e.g. EPC, TID, USER) that are displayed in the data
field.
④
Length of the data area (the field can be edited when
"Total" is not checked)
⑤
Data field
The data can be displayed in either hexadecimal, decimal
or ASCII format.
⑥
Buttons for processing the tag data:
Scan tag (ID)
•
Read tag data
•
Write to the tag
•
⑦
Indication of the tag type
⑧
The editor window contains the tag data. The size of the
represented data depends on the tag type.
⑨
(Start) address (the field can be edited when "Total" is not
checked)
⑩
"Complete" check mark: Indication of the completely
selected memory area; all memory areas of the tag are
always read or written at once, independent of the memory
area currently set.
⑪
Length of the user area:
The software "RF-MANAGER" contains an additional field
for the length of the user area. In this field, you must enter
the tag-specific length of the user area.
③
], you can select and display the different memory areas of the tag. If
⑩
, the current memory area will be displayed complete in the editor,
The software "RF-MANAGER"
8.3 Application mode "Mobile"
⑨
] and "Length" [⑩] to display the
35
Advertisement
Table of Contents
