Table of Contents
Advertisement
Writing the complete tag
If all memory areas of the tag are to be completely read or written together, set the check
mark for "Complete".
With this function you can display the complete size of the selected memory area.
If the check mark is set for "Complete", "Read all" and "Write all" are displayed on the
buttons.
Figure 8-6
Note
ID check
It is checked for all tags before any read or write procedure whether the tag ID displayed in
the editor corresponds to the ID of the tag that is located in the field of the SIMATIC
RF680M. If this is not the case, time-out will be displayed after 20 seconds.
See also
Settings (Page 75)
8.3.3
Overview of functions
When the RF-MANAGER application starts up, the screen for scanning tags appears on the
display. You can then scan tags or call a function from the menu. You can find out from the
following table which functions are available in the respective application mode.
Note
If you want to use the function "Edit Tag" in application mode "Mobile", you must activate this
in RF-MANAGER.
SIMATIC RF680M Mobile Reader
Operating Instructions, 06/2011, J31069-D0241-U001-A2-7618
"Write All" button
The software "RF-MANAGER"
8.3 Application mode "Mobile"
41
Advertisement
Table of Contents
