NEC SigmaBlade N8406-040(F) User Manual page 191

Restoring Setting Information
Confirm that the 8G FC Switch is connected to the proper network.
1.
NOTE:
To restore the setting information, various settings in the 8G FC Switch must be stored
in a text file to be transmitted to the FPT server. Accordingly, the 8G FC Switch must be
connected to the network.
Confirm that the FTP server is accessible.
2.
NOTE:
To restore the information set on the 8G FC Switch, transmit the text file containing the
setting information to the FTP server.
Login to the console on the 8G FC Switch.
3.
Type "switchdisable" command on the console screen.
4.
IMPORTANT:
The setting file cannot be reset during system operation.
Running the command causes the 8G FC Switch to be disabled.
Type "configdownload" command on the console screen.
5.
ALE044120T2:admin> configdownload
Protocol (scp, ftp, local) [ftp]:
Server Name or IP Address [host]: 192.168.1.100
User Name [user]: fc
Path/Filename [<home dir>/config.txt]:
Section (all|chassis|switch [all]):
This command is used to download a backed-up configuration
for a specific switch. If using a file from a different
switch, this file's configuration settings will override
any current switch settings.
file, which was uploaded from a different type of switch,
may cause this switch to fail. A switch reboot might be
required for some parameter changes to take effect.
configDownload operation may take several minutes
to complete for large files.
Do you want to continue [y/n]: y
Password:
duplicate license-key "*******************************"
Doing configDownload on switch ...
Activating configDownload without disabling switch:
NOTE: Not all configuration parameters will be downloaded with switch online
configDownload complete: All selected config parameters are downloaded
ALE044120T2:admin>
Type "switchenable" command on the console screen.
6.
*** CAUTION ***
Downloading a configuration
- 191 -