Take out the 8G FC Switch from the Blade Enclosure (SIGMABLADE).
5.
IMPORTANT:
Do not hold the ejector to remove the 8G FC Switch from the Blade Enclosure. Hold the
8G FC Switch itself and remove it from the slot. The ejector may break off, causing
injury if the 8G FC Switch falls.
Install a blank cover in the switch module slot from which the 8G FC Switch was just removed.
6.
NOTE:
For installing a blank cover in the Blade Enclosure (SIGMABLADE), refer to the
User's Guide of the Blade Enclosure (SIGMABLADE).
- 135 -