Table of Contents
Advertisement
Push the ejector to lock the stopper. The 8G FC Switch is fixed.
5.
NOTE:
The installation/removal procedures of the 8G FC Switch in/from a Blade
Enclosure
(SIGMABLADE)
varies
depending
on
the
Blade
Enclosure
(SIGMABLADE). For the procedure, always refer to the relevant Blade Enclosure
(SIGMABLADE).
If the 8G FC Switch cannot be installed in a Blade Enclosure (SIGMABLADE)
properly, remove the 8G FC Switch once and reinstall it again. Applying excess
force to the 8G FC Switch may cause it to be damaged. After the 8G FC Switch is
removed, wait for more than 30 seconds and then reinstall it.
- 133 -
Advertisement
Table of Contents
