Make And Receive Calls; Reset To Factory Defaults - Yeastar Technology TA Series Installation Manual

Note: please note that after changing the IP address of LAN port, TA device should
be rebooted to make the new changes to take effect.

4.4 Make and Receive Calls


TA FXS Gateway
1. Internal calls between FXS ports
Two analog phones connected to TA could make calls between them by dialing
*99+FXS port number.
2. Outbound and inbound calls
Users should be able to make and receive external calls after configuring FXS
Ports, VoIP Server, and Dial Pattern. Please refer to User Manual for details.

TA FXO Gateway
1. Route calls from a PSTN number to IP-PBX
Users should be able to receive PSTN-to-VoIP call after configuring FXO Ports,
VoIP trunk and Port -> IP. Please refer to User Manual for details.
2. Route calls from VoIP trunk to a PSTN number
Users should be able to make VoIP-to-PSTN call after configuring FXO Ports,
VoIP trunk and IP ->Port. Please refer to User Manual for details.

4.5 Reset to Factory Defaults

To reset to factory defaults, you could follow the below instruction:
Press the "RESET" button located in the back panel with a paper clip or a pencil tip.
You can see the RUN indicator stops flicker and turns solid. When the RUN indicator
turns off, the button could be released and system begins to reset.
Note:

During the process, please do not power off until the RUN indicator become
normal which means the reset process is completed.

After resetting, all the configurations made by the admin would be erased.
TA Series Installation Guide
16/17