Network Settings; Make And Receive Calls - Yeastar Technology NeoGate TA FXS Quick Installation Manual

Enter the Admin User Name and Password to log in.
Via the configuration interface, the admin can make all the system configurations, including network settings
(LAN, WAN, Firewall, VPN, DDNS, VLAN, etc.); system parameters configuration (time zone, password, etc.);
internal settings (Web access port, music on Hold, etc.); FXS ports list, Hunting Groups; call logs (search,
download); firmware update and reset, etc.
After saving the changes, remember to click the "Apply changes" button to make the changes take
effect.

4.3 Network Settings

After logging in the admin configuration interface, generally the first step is to configure the IP address. If the
LAN ports are connected to the network, their IP addresses need to be configured. If not, just configuring the
IP address of the LAN port which is connected to the local area network of the company is OK.
 LAN Settings
Click "Network Preferences"-> "LAN Settings" on the left menu bar of the web configuration interface.
LAN port is used for the interoperability of IP terminals and NeoGate. If the LAN port is connected to the
company's LAN, please configure the correct IP address and corresponding subnet mask.
Please note that after changing the IP address of LAN port, NeoGate should be rebooted to make the new
changes taking effect.

4.4 Make and Receive Calls

1. Internal calls between FXS ports
Two analog phones connected to NeoGate TA could make calls between them by dialing *99+FXS port
number.
http://www.yeastar.com
NeoGate TA FXS Gateway Quick Installation Guide
Figure 4-2 NeoGate Admin Configuration Interface
11/12