Regulations Covering Insert Installation; Clearances To Combustible Material; Location Of The Certification Label - Enerzone Destination 1.5 Installation And Operation Manual

Table of Contents

7.2 Regulations Covering Insert Installation

When installed and operated as described in these instructions, the Destination 1.5 wood insert is

suitable for use in residential installations. The Destination 1.5 wood insert is not intended for

installation in a bedroom.

In Canada, the CSA B365 Installation Code for Solid Fuel Burning Appliances and Equipment and

the CSA C22.1 Canadian National Electrical Code are to be followed in the absence of local code

requirements. In the USA, the ANSI NFPA 211 Standard for Chimneys, Fireplaces, Vents and

Solid Fuel-Burning Appliances and the ANSI NFPA 70 National Electrical Code are to be followed

in the absence of local code requirements.

This insert must be installed with a continuous chimney liner of 6" diameter extending from the

insert to the top of the chimney. The chimney liner must conform to the Class 3 requirements of

CAN/ULC-S635, Standard for Lining Systems for Existing Masonry or Factory-built Chimneys and

Vents, or CAN/ULC-S640, Standard for Lining Systems for New Masonry Chimneys.

NOTE: The Insert is not approved for use with a so-called "positive flue connection" to the clay

tile of a masonry chimney.

The clearances shown in this section have been determined by test according to procedures set

out in safety standards ULC S628 (Canada) and UL1482 (U.S.A.). When the insert is installed so

that its surfaces are at or beyond the minimum clearances specified, combustible surfaces will not

overheat under normal and even abnormal operating conditions.

No part of the insert may be located closer to combustibles than the minimum clearance

figures given.

Since the information given on the certification label attached to the appliance always overrides the

information published in any other media (owner's manual, catalogues, flyers, magazines and/or

web sites), it is important to refer to it in order to have a safe and compliant installation. In addition,

you will find information about your insert (model, serial number, etc.). The certification label can be

reached by following these steps:

1. Open the loading door.

2. On the left side of the appliance,

unfasten the screw (B) holding the

certification label plate (A) place.

Destination 1.5 Insert Installation and Operation Manual

Table of Contents

Destination 1.5 insert