Enerzone Destination 1.5 Installation And Operation Manual page 25

The gasket must be centred on the edge of the glass. To do this easily, peel back a section of the
paper covering the adhesive and place the gasket on a table with the adhesive side up. Stick the
end of the gasket to the middle of top edge of the glass, then press the edge of the glass down
onto the gasket, taking care that it is perfectly centred on the gasket. Peel off more of the backing
and press the whole length of the edge of the glass onto the gasket. Do not stretch the gasket as
you place it. Cut to the necessary length. Now pinch the gasket to the glass in a U shape over the
front and back of the glass. Do the same for the bottom edge of the glass.
Emplacement Longueur Dimensions
Around glass 33 3/8" (848 mm) (2X) "U" shaped self adhesive
Derrière la vitre 80" (2 M) Flat, self-adhesif (1/8" x 1")
Another glass gasket (C) is located on the door frame, behind the glass. When replacing the glass
or as needed, install according to following illustration. Note that on the door frame, there is a light
groove to show position of the gasket.
Reinstall the glass, being careful to centre the glass carefully in the door. Do not over-tighten the
screws. Note that the two main causes of broken door glass are uneven placement in the door and
over-tightening of retaining screws.
Do not abuse the glass door by striking or slamming shut. Do not use the insert if the glass is
broken. To change the glass, perform the same operation described above.
Destination 1.5 Insert Installation and Operation Manual
25