Monitoring Audio; Cueing Up; Adding Shot Marks During Playback (Udf, Exfat, And Fat Hd Mode); Clip Operations - Sony PXW-X200 Operating Instructions Manual

Monitoring Audio

In Normal playback mode, you can monitor the
recorded audio signals through the built-in
speaker (page 8) or connected headphones.
With the headphones connected to the headphone
connector (page 7), the built-in speaker is turned
off.
Press the VOLUME buttons (page 9) to adjust the
sound volume.
You can select audio channel(s) to be monitored
with "Audio Output" (page 92) of the AUDIO
SET menu.

Cueing Up

To start playback from the top of the first clip
Press the PREV button and F REV button
simultaneously. The top of the first-recorded clip
on the memory card is cued up.
To start playback from the top of the last clip
Press the F FWD button and NEXT button
simultaneously. The top of the last-recorded clip
on the memory card is cued up.
Adding Shot Marks During
Playback (UDF, exFAT, and FAT HD
Mode)
In the same manner as in recording, you can add
shot marks to the clip during playback.
At the point where you wish to add a shot
mark, press the "Shot Mark1" or "Shot
Mark2" assigned button.
Notes
• No shot mark can be added if the memory card is write-
protected.
• No shot mark can be added to the first or last frame of
a clip.

Clip Operations

During thumbnail screen playback, etc., you can
operate the clips or confirm and change the
subsidiary data for clips using the Clip Operation
menus. The corresponding Clip Operation menu
pops up on the screens as shown below when you
press the SEL/SET button or the jog dial.

Clip Operation Menus

Thumbnail screen (page 72)
CANCEL
DISP CLIP INFO
OK MARK ADD (FAT only)
OK MARK DELETE (FAT only)
OK FLAG ADD (UDF and exFAT)
NG FLAG ADD (UDF and exFAT)
KEEP FLAG ADD (UDF and exFAT)
CLIP FLAG DELETE (UDF and exFAT)
LOCK CLIP (UDF and exFAT)
UNLOCK CLIP (UDF and exFAT)
COPY CLIP
DELETE CLIP
ALL MARKS
SHOT MARK1
SHOT MARK2
REC START MARK (UDF and exFAT)
EXPAND CLIP
Clip Operations 71